Nobody downloaded yet

Environmental fluid mechanicsopen channel flow - Lab Report Example

Comments (0) Cite this document
Summary
6. Comparing the total energy plots at different positions, you will notice that at some points, The result of energy drops to several units. This is an indication that there is a hydraulic jump in this particular portion of the experiment rendered…
Download full paperFile format: .doc, available for editing
GRAB THE BEST PAPER94.6% of users find it useful
Environmental fluid mechanicsopen channel flow lab report
Read TextPreview

Extract of sample "Environmental fluid mechanicsopen channel flow"

Download file to see previous pages The head lost occurs at the point where the measured calibration is at 35.00mm. The hydraulic jump normally occurs when the upstream flow is supercritical. In the experiment rendered, the hydraulic jump occurs at a point where the calibration reading is 35.00 mm.
7. In the course of the experiment, the different flow characteristic of flow pattern, are seen in the graph of the supercritical and subcritical at points (calibration= 30.0mm.)The regions where each of the typical flow patterns takes place iat the hydraulic jump position.
... ...Download file to see next pagesRead More
Cite this document
  • APA
  • MLA
  • CHICAGO
(“Environmental fluid mechanicsopen channel flow lab report”, n.d.)
Environmental fluid mechanicsopen channel flow lab report. Retrieved from https://studentshare.org/miscellaneous/1527197-environmental-fluid-mechanicsopen-channel-flow-lab-report
(Environmental Fluid Mechanicsopen Channel Flow Lab Report)
Environmental Fluid Mechanicsopen Channel Flow Lab Report. https://studentshare.org/miscellaneous/1527197-environmental-fluid-mechanicsopen-channel-flow-lab-report.
“Environmental Fluid Mechanicsopen Channel Flow Lab Report”, n.d. https://studentshare.org/miscellaneous/1527197-environmental-fluid-mechanicsopen-channel-flow-lab-report.
  • Cited: 0 times
Comments (0)
Click to create a comment or rate a document

CHECK THESE SAMPLES OF Environmental fluid mechanicsopen channel flow lab report

Civil engineering level 1 Fluid Mechanics Lab report (oriphis and free jet flow)

...?INTRODUCTION Orifice is a term used for a small hole or opening in a vessel which enables the fluid to flow through it. Fluid keeps on flowing through the orifice as long as the head of fluid is above the level of orifice in the vessel. Orifice is not merely a hole but is considered as one of the fundamental equipment used in fluid mechanics as it is widely used to measure discharge rates and velocity coefficients(CodeCogs, 2013). Orifice can have any shape. It can be round, square, oval etc. Also it can be smooth of rough as well. There are a number of applications for this device. Some of which are listed below(Nally, 2013): Used to...
3 Pages(750 words)Essay

Open Channel Flow

...Open Channel flow Introduction Open Channel flow refers to fluid flow that is exposed to atmospheric pressure. Examples of open channel flow include Half Full Culverts, streams, rivers, etc. In open channel flow, the pressure on the surface of the flow is assumed to be constant. Also, the hydraulic grade line is assumed to be at the surface of the flow. The flow in open channel flow is classified as steady or unsteady. The steadiness or unsteadiness of the flow is...
3 Pages(750 words)Lab Report

Environmental Fluid Mechanics

...CIVL 3076 Environmental Fluid Mechanics Design of an Open Channel with Assessment of Pollution Transport Introduction An open channel is defined as aconduit in which a liquid flow with a free surface. The flow normally occurs under pressure as contrasted with liquid in a pipe, the liquid conveyed by an open channel exerts no pressure other than that caused by its own weight, and pressure of the atmosphere. The general theory applies to all liquids but since there are a few test data available on open-channel flow of liquids other than water at natural temperatures, it only applies to...
8 Pages(2000 words)Essay

Lab Report - Blood Flow and Vascular Function

...Lab Report: Assessment of Blood Flow and Vascular Function The cardiovascular system is essentially comprised of blood vessels and of the heart. The purpose of blood vessels is to transport blood into and out of the heart. The two major types of blood vessels are arteries and veins. It is the responsibility of arteries to carry oxygenated blood away from the heart and to the body’s organs, under relatively high pressure, as compared to the pressure under which the veins opperate. The pulmonary artery is the only artery that does not actually transport oxygenated blood away from the heart. Arteries are composed of narrow lumens and elastic muscle tissue. It is the sympathetic nervous system which sends out signals to arteries... ...
12 Pages(3000 words)Article

Lab report

...SUMMARY SHEET Physics Laboratory Report -- Equilibrium of a Rigid Body Objective To be able to determine the center of gravity of a rigid body andpositions of weights with reference to that center that would establish equilibrium of forces and torques Method Obtain the weight (in Newton) of the meter stick and the average weight of the three meter stick clamps. Balance the meter stick in one of the clamps to determine its center of gravity. Place a clamp on one end of the stick to carry a 100-gram weight and slide the stick through the supporting clamp to locate the balance (position of the axis of rotation). Then place another clamp with a 200-g suspension and repeat the same previous step. Record positions with respect...
3 Pages(750 words)Lab Report

Lab Report

... Last 4 digits of ID: 7989 Section: Lab Spring Laboratory 7:  Ecological Niche (15 points) Part I: Definitions and Backgroundinformation 1. The niche of an organism is the overall interactions of an organism with other organisms and its range of needs (Properties of microbes). 2. Organisms might compete for food, light, and space. 3. Evolution is the process of gradual development of organisms from simple structures to intricate forms over time. Competition affects the process of evolution in that the organism that is able to compete favorably for the available resources survives and continues to thrive, whereas the organism that cannot compete favorably dies and becomes extinct. Part II: Results Table 1: Effects of Temperature...
1 Pages(250 words)Lab Report

Environmental lab

...% of the greenhouse gases and it needed in bulk. In comparisons of the two in terms of energy potential, nuclear produces 10100 energy from an equivalent 1 kg of both. Therefore, there is no doubt nuclear potential is very impressive, but the two have got environmental impacts that needs thorough consideration (Caldicott, 2007). Hypothesis/Predicted Outcome Nuclear energy is safer and cleaner than coal Methods For this research, the main methodology for data collection was animation from MUSE lab. After login, data was collected in accordance with the time changes along the time frame. The data on the quantity of carbon, sulphur, amount of both uranium and coal needed, and...
1 Pages(250 words)Assignment

Environmental lab

...Identifying Environmental Hazards Identifying Environmental Hazards Purpose To identify the impact of invasive species to the ecosystems, especially Zebra and Quagga Introduction Invasive species have posed a threat to the ecosystem in several ways. In some instances, they outcompete indigenous species for space and nutrients and at the same time they can spread diseases. Zebra and Quagga have demonstrated that they severely compete for phytoplankton with other organisms in the ecosystem, which result in alteration of the food web. The far reaching impact of these invasive species can lead to extinction in the long run. Further, the only alternative way to solving this, is by getting reed...
1 Pages(250 words)Assignment

Heat transfer and fluid flow

... Heat Transfer and Fluid Flow Use steam tables where necessary to find thermophysical properties of water The following equations and data may be useful: Surface area of a cylinder of length H and radius r = Surface area of a sphere = 4r2 = d2 Stefan-Boltzmann constant, , = 5.67  10–8 W m–2 K–4 Latent heat of melting of ice = 333.5 kJ kg–1 Temperature in kelvins ≈ Temperature in C plus 273. Note that the purpose of this coursework is to demonstrate both subject knowledge and competency in methodology and communication. Full marks will therefore only be given for both a correct answer and sensible and clear method. Remember, the coursework is marked harshly, to highlight...
3 Pages(500 words)Coursework

Marking Machine / Fluid Power Lab

... Results Figure Circuit diagram Figure 2: Displacement set up diagram. Figure 3: displacement time diagram Switch 2 is used as the actuating start condition of the system. When the push button is pressed on switch 1, two signals re sent out to pressure valve 1 and then pass the signal on to port 14. Being a one way control, valve 3 will reverse and result into the advancing of the rod of the cylinder at a given speed depending on the settings. When the cylinder finally reaches the forward end position, it activates switch 3 and air fills the valves and the adjusted time is elapsed. Valve 2 then passes the pressure signal to port 12 on valve 3 which then reverses and the rod goes back to its initial position. Conclusion... Results Figure...
1 Pages(250 words)Lab Report
sponsored ads
We use cookies to create the best experience for you. Keep on browsing if you are OK with that, or find out how to manage cookies.

Let us find you another Lab Report on topic Environmental fluid mechanicsopen channel flow lab report for FREE!

Contact Us