Using Thin Layer Chromatography - Essay Example

Centrifuge tube of 50mL polypropylene to sample preparation of toothpaste with a weight of around 1.0g. To disperse the toothpaste, add 5mL of water and vortex for around 1 minute. Next is the addition of 5mL of acetonitrile to the mixture followed by a vortexon x about 1 minute. Before collecting around 1mL of the supernatant, centrifuge the mixture until you obtain a crystal-clear solution. Make use of the 1.5mL micro test tubes by transferring 500L of the supernatant to it then add 1.0mL of methanol. Dilute 0.2mL of DEG to 0.5mL using methanol to achieve the standard reference preparation (Ahuja & Scypinski, 2011). Spread the 5L diluted test solution and the reference standard solution on a sheet and leave it to dry. To get commendable results, use chromatographic procedure spot.
            The next step is to put the sheet in a developing tank that has been prepared by balancing 100mL of developing a solvent for about 30minutes. Remove the solvent and permit it to dry in the air immediately after the developing solution reaches the stopping line. When you submerge the dried sheet in potassium permanganate solution and then remove the sheet after around 5 seconds, yellows spots will start to appear on the background as the sheet begins to dry. The last spot to appear is DEG.
            The reading of DEG varies from 0.40%, 0.41% and 0.44% for OOS results and between 0.005% and 0.015% for OOS deviation. According to Ahuja and Scypinski (2011), after the examination of the OOS results, the procedures on the discovery and occurrences of the OOS are recorded.