Nobody downloaded yet

Analytical chemistry - Assignment Example

Comments (0) Cite this document
Summary
The article titled Differential pulse voltammetric determination of Albendazole in pharmaceutical tablets using a cathodically pretreated boron-doped diamond electrode by Lourencao, Baccarin, Medeiros, Rocha-Filho & Fatibello-Filho (2013) discusses the use of differential pulse…
Download full paperFile format: .doc, available for editing
GRAB THE BEST PAPER91% of users find it useful
Analytical chemistry
Read TextPreview

Extract of sample
"Analytical chemistry"

Download file to see previous pages n used in the advancement of a sensitive method that can be used to judge ABZ put in pharmaceutical formulations through the use of differential pulse voltammetry (DPV) method (Lourencao, Baccarin, Medeiros, Rocha-Filho & Fatibello-Filho, 2013).
The main aim was to provide the above information on the above issue both in veterinary and human medicine. The paper adds to the few studies that have been done on electrochemical behavior and the quantification of ABZ. It also serves to add information on the use of several methods that have been used in the definition of ABZ and its main metabolites including chromatographic and spectrophotometric methods.
The electrochemical behavior of the ABZ was studied using three voltammetric techniques that included cyclic voltammetry (CV), square-wave voltammetry (SWV) and differential pulse voltammetry (DPV) methods. All the three methods were used to determine which one among them was the best in the evaluations to enable the authors come up with a trustworthy result and conclusion on the investigations. The cyclic voltammetry was used was only used for preliminary studies because it is not as sensitive and detailed as the other procedures (Lourencao, Baccarin, Medeiros, Rocha-Filho & Fatibello-Filho, 2013).
The three methods were used to find the best conditions for determining ABZ. After optimization of the of the limitations of the experiment for the methods, the result was used to draw curves by adding the aliquots of the stock solution of the ABZ to electrochemical cell that had 10 mL of 0.05 mol L-1 H2SO4. All the experiments were done through an Autolab PGSTAT-30 potentiostat that was controlled by the GPES 4.9 software. The experiment also employed the use of a three-electrode sell system where a BDD electrode was the working one, an Ag electrode as the reference and the platinum wire as the auxiliary electrode. The experiment also used an LC-10 AT Shimadzu system to determine the ABZ through a high performance ...Download file to see next pagesRead More
Cite this document
  • APA
  • MLA
  • CHICAGO
(“Analytical chemistry Assignment Example | Topics and Well Written Essays - 750 words”, n.d.)
Retrieved from https://studentshare.org/chemistry/1683117-analytical-chemistry
(Analytical Chemistry Assignment Example | Topics and Well Written Essays - 750 Words)
https://studentshare.org/chemistry/1683117-analytical-chemistry.
“Analytical Chemistry Assignment Example | Topics and Well Written Essays - 750 Words”, n.d. https://studentshare.org/chemistry/1683117-analytical-chemistry.
  • Cited: 0 times
Comments (0)
Click to create a comment or rate a document
CHECK THESE SAMPLES - THEY ALSO FIT YOUR TOPIC
Chemistry chemistry
...CHEMISTRY QUESTIONS Presented Intramolecular forces operate within the molecules or fundamental units of a substance. This would include the attraction between positive and negative ions in a crystal of an ionic compound, the covalent bonds in a molecular substance as well as the covalent bonds linking atoms in a network structure, such as that of carbon (diamond).Metallic bonds are also classified as intramolecular forces (Frederick, 1979, P.63)Intermolecular forces operate between, rather than within, the molecules of a covalent substance. This would include the attractions exerted by one molecule of a molecular substance on another, such as the force of attraction between water molecules in ice ,the attractions between atoms... relative...
2 Pages(500 words)Essay
Chemistry
...Chemistry: Q1. Arsenic sulphide has 70% arsenic mass, with the remainder being sulphur. Use the % composition of arsenic and sulphur to obtain the empirical formula of the compound Sulphur percentage is 30% and 70% arsenic therefore the ratio is 3:7 This means that the number of atoms for Sulphur = 3 Arsenic = 7 Therefore the empirical formula will be Ar7S3 (s) Q 2 Sample mass/g Temperature / C Pressure/ mm Hg volume / cm 0.345 650 760 60.5 0.345 1573 760 242.0 Use above table for the questions below. (i) Using the information for 650C,...
2 Pages(500 words)Essay
Chemistry
...x100 = 65.62%. 137x27 Question – 3 a. In 1870, Markonikov laid down a basic principle of chemistry that holds till today. The Markonikov Rule states that when a hydrogen halide (Hydrochloric acid, HCl being an example) reacts with an asymmetrically substituted alkene the hydrogen attaches itself to the carbon atom that has the larger number of its hydrogen atoms substituted. The halogen automatically attaches itself to the carbon atom having the least number of its hydrogens substituted. An example of such an addition reaction: Cl2HC=CH2Cl + HCl  Cl2H 2 C=CH2Cl2 Here the halide chlorine attached to the right hand side of the molecule that had fewer hydrogen atoms replaced. b. Enantiomers...
4 Pages(1000 words)Essay
Chemistry
... Institute of Mental Health (NIMH). 10 June 2006. Sachs GS, Printz DJ, Kahn DA, Carpenter D, Docherty JP. The expert consensus guideline series: medication treatment of bipolar disorder 2000. Postgraduate Medicine, 2000; Spec No:1-104 Tondo, L., Baldessarini, R., Hennen, J., & Floris, G. (1998). “Lithium treatment and risk of suicidal behavior in bipolar disorder patients.” Journal of Clinical Psychiatry, 59, 8-19. Ann Arbor. The University of Michigan. October, 2000. Evidence of Brain Chemistry Abnormalities in Bipolar Disorder. Durand, V. M. & Barlow, D. H. 2000. Abnormal Psychology: An Introduction. Scarborough, Ontario: Wadsworth. Glazer WM, Sonnenberg JG, Reinstein M (2005), A novel, "point... and moods of a person could be correlated...
5 Pages(1250 words)Essay
Chemistry
...Chemistry Question One A and B Properties of gold, cube Density of gold = 19.3g/ml A Mass 11.439g B Volume of water 5.1ml With gold cube = 5.7ml a) The graduated cylinder has an accuracy of 0.1 ml, the electronic balance has an accuracy of 0.0001 g. according to the measurements given on volume they are accurate according to the minimum readable measurement given by the cylinder. The measurement given on the mass seems not to be accurate because the minimum measure of mass according to the apparatus is 0.0001, therefore if the measure was exactly 11.439 g then this should have been written as 11.4390 g. b) Volume of the gold cube 5.7 – 5.1 = 0.6ml c) Density and mass find volume of gold cube Density = Mass/Volume Volume =...
6 Pages(1500 words)Essay
Chemistry
...Chemistry Describe the configuration of an atom. An atom is composed of a nucleus. The atom also possesses atomic orbitals and energy levels which are made up of electrons. 2.) Explain the process of radioactive decay which takes place on (^14)(^6)C or what is known as carbon 14. A radio carbon such as carbon 14 will undergo a process of electron mission, therefore losing energy and moving ultimately to a place of chaos or entropy. The following formula will illustrate the radioactive beta decay which will act on carbon 14: ^14_6C------> ^14_7N+e 3). Utilize the S P D orbital system to describe Potassium. An orbital is essentially a theory of something rather than an actual something. This orbital is said to contain...
2 Pages(500 words)Essay
Organic and analytical chemistry
...Organic and Analytical Chemistry Infra-red spectroscopy (IR), Mass Spectrometry (MS), and Nuclear Magnetic Resonance spectroscopy (NMR). are three basic methods that are commonly used for the identification of organic compounds. Each of these techniques measures specific properties of molecules that are unique to the particular compound and can be used to determine the structure of its molecules. Together, the information from MS, IR and NMR can be used to determine the chemical identity and three-dimensional structure of the molecules of an unknown compound. MS provides information about the different component pieces of a molecule according to their masses. IR provides information about the functional groups that are present... Magnetic...
2 Pages(500 words)Essay
Chemistry
...Hydrogen Introduction Hydrogen is one of the essential elements of life however very few individuals understand its complex series of uses. While itwas first detected as early as the 16th century, it wasn’t until nearly two-hundred years later that it was rediscovered and given its chemical name. Hydrogen combines to form a countless number of compounds that position it as a cornerstone to life in the universe. It is an essential element in things as essential as water, as small as healing cuts and bruises, and as large and industrial as oil refinement. This essay examines the historical background of hydrogen, its chemical formula and elements, as well as its use in compounds that make up the fabric of our very existence... Introduction...
7 Pages(1750 words)Research Paper
Chemistry
... Introduction to Chemistry: Analysis of Oxygen (O2) Introduction Oxygen is a chemical element that largely forms part of the atmospheric and is widely recognized with the sustenance of life and survival of organisms. It has a formula of O­2. As a chemical element, this substance has an atomic number of 8 and belongs to the chalcogen group on the periodic table; thus, making it build and possess certain significant characteristics for its operations such as being a highly reactive non-metallic element. Subsequently, oxygen is widely used as an oxidizing agent through its readiness to form compounds (in most cases oxides), with most of the atmospheric elements (Bauer, Birk & Pamela 145-149). Identification by mass sets this element... in...
4 Pages(1000 words)Term Paper
Analytical chemistry assignment 12 questions
...ANALYTICAL CHEMISTRY ASSIGNMENT due Explain the problems encounter when making chemical measurements, define the terms analyte, matrix and interferent (5 Marks). Some of the problems encountered when making chemical measurements include the complexity of the measuring equipment and the expertise of the personnel. Some procedures may not produce reliable results without complicated measuring equipment while others may require highly trained staff to perform the procedures. An analyte can be defined as the substance or component that is of interest in a chemical analysis procedure. It is the chemical constituent that is being measured. A matrix, on the other hand, can be...
5 Pages(1250 words)Essay
sponsored ads
We use cookies to create the best experience for you. Keep on browsing if you are OK with that, or find out how to manage cookies.
Let us find you another Assignment on topic Analytical chemistry for FREE!
logo footer
Contact us:
+16312120006
Contact Us Now
FREE Mobile Apps:
  • StudentShare App Store
  • StudentShare Google play
  • About StudentShare
  • Testimonials
  • FAQ
  • Blog
  • Free Essays
  • New Essays
  • Essays
  • Miscellaneous
  • The Newest Essay Topics
  • Index samples by all dates
Join us:
Contact Us